All Blog

Troubleshooting

Low water pressure? Start with these three checks

Before you call anyone, check the aerator, the main shut-off, and the pressure regulator. Two of the three you can handle yourself.

Dev Patel

Pressure complaints are the most common call we take, and roughly half of them are resolved before a technician opens a toolbox. Working through these three checks in order will tell you which half you are in.

Start at the fixture

If only one tap is weak, unscrew the aerator at the spout and rinse the screen. Mineral scale builds up there faster than anywhere else in the house, and a two-minute clean often restores full flow. Shower heads are the same story with a longer soak.

Check the main shut-off

If every outlet is weak, find the main valve and confirm it is fully open. A valve left three-quarters open after a repair looks open at a glance and will throttle the whole house indefinitely.

While you are there, check the isolation valve on the incoming meter as well. Both need to be wide open, not just on.

The pressure regulator

If the fixtures are clear and the valves are open, the regulator is the likely culprit. These fail gradually, and a failing one can send pressure too low or dangerously high without any obvious warning.

This is the one to leave to us. The regulator sits under full mains load, and replacing it means isolating the supply properly. We measure static pressure first so you know whether it is genuinely the cause before anything is changed.

Create a free website with Framer, the website builder loved by startups, designers and agencies.